Bosch Rexroth Sytronix FcP 50 Series Operating Instructions Manual page 51

DOK-SYTROX-MPES2******-IT01-EN-P
Rexroth Sytronix FcP 50xx/70xx Motor-Pump Unit MPES2
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
4. Screw on motor on bellhousing.
Fasten the motor 5 with screws 5.1 onto the bellhousing 2. When joining
the coupling heed the correct seat of the ring gear 3.2.
In the case of fastening A and B acc. to the type code, the leakage hole
must be at the bottom that escaping oil can flow out.
Fig. 7-2: Leakage hole
5. Screw on bellhousing (optionally for A10VZO)
Fasten the optional pump foot 4 with the screws 4.1, washers 4.2 and
hexagon nuts 4.3 on the motor-pump unit.
X Assembly dimension pump: front face of hub to front face of
P
pump shaft
X Assembly dimension motor hub: front face of hub to front face
M
of motor shaft
|← Assembly of hub as far as it will go
Fig. 7-3: Assembly dimension (see
dimensions" on page 51
ting dimension " on page
Clamping screws coupling hub
Threaded pin
3.4
KD
3.5a
G
24 M5
28, 38 M8
42 M8
48 M8
55, 65 M10
75 M10
KD Coupling size
Tab. 7-1: Tightening torque clamping screws of coupling hub
Bosch Rexroth AG
fig. 7-5 "Assembly accessories and setting
and fig. 7-8 "Assembly accessory and set‐
54)
Cylinder screw
3.5b
M [Nm]
G
A
2 M6
10 M8
10 M10
10 M12
17 M12
17 M16
49/143
Mounting
M [Nm]
A
14
35
69
120
120
295