Table of Contents
Advertisement
DOK-SYTROX-MPES2******-IT01-EN-P
Rexroth Sytronix FcP 50xx/70xx Motor-Pump Unit MPES2
7
Mounting
7.1
General
7.2
Unpacking
7.3
Installation Conditions Motor-Pump Unit
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Motor-pump units are mounted ex works, or delivered as kit for assembly by
the customer. This chapter describes the following assembly procedures:
●
Assemble the motor-pump unit composed of components
●
Assemble Motor-Pump unit
For information about assembly into the whole machine, especially informa‐
tion about total functions and logical effects refer to the instructions or docu‐
mentations of the whole machine.
CAUTION
Maintain a sufficient distance and carefully cut the bandages.
Remove the packaging of the motor-pump unit.
Dispose the packaging according to the local valid regulations.
Before assembling the motor-pump unit, ensure the following:
●
Use tools, supplies, measuring and test equipment.
●
Check all components for visible damage. Damaged components may
not be mounted.
●
Ensure that all dimensions and tolerances on the machine side are suit‐
ed for the component attachment.
●
Inspect all components, mounting surfaces and threads to ensure they
are clean.
●
Make sure that the assembly can be carried out in a dry and dust-free
environment.
●
Ensure that the motor-pump unit and all other used parts are clean,
when they are mounted.
A polluted hydraulic fluid can considerably influence the lifetime of
the drive unit.
●
Ensure that the temperature of the motor-pump unit is according to the
environmental temperature of the installation site. Allow sufficient time to
the components to adjust the temperature conditions.
●
Before assembling the motor-pump unit, remove fluids that might have
been filled in for storing the pump.
●
Please observe that the motor-pump unit is not suited for mounting the
pump under oil.
●
Ensure that the minimum distance between fan screen and machine is
kept to suction/blow the air.
Bosch Rexroth AG
Injuries due to uncontrolled movement of the
retaining straps when cutting!
47/143
Mounting
Advertisement
Table of Contents
Troubleshooting
