Components (Front); Figure 3 Operation Panel; Table 1 Status And Meanings Of Each Led (Operation Panel) - Fujitsu ETERNUS AF250 S2 Basic Operation Manual

1. Component Names and LED Names
Controller Enclosures

Components (Front)

This section describes the operation panel and the drives in the front of the controller enclosure.
■
Operation Panel
An operation panel has LEDs, a Power switch, and a FUNCTION button.
Figure 3 shows the operation panel.

Figure 3 Operation Panel

A
1
3
5
7
A. With a flange cover
B. Without a flange cover
1. Power switch
This switch is used to turn on or off the ETERNUS AF.
2. POWER LED
3. IDENTIFY LED
4. FAULT LED
5. MAINTENANCE LED
6. CACHE LED
7. READY LED
8. FUNCTION button
This button is used to switch the maintenance status on or off, to switch the master CM, to initialize the LAN
ports, or to initialize the user settings.
The LEDs turn on or blink to indicate the statuses that are listed below.

Table 1 Status and Meanings of Each LED (Operation Panel)

LED name
POWER
IDENTIFY
Table 1 shows the status and meanings of each LED.
1
2
3
4
5
6
7
LED status
(green)
(blinks blue)
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Operation Guide (Basic)
Copyright 2019 FUJITSU LIMITED
B
2
4
6
8
Meaning
DC power is supplied to the ETERNUS AF.
The installation location of the ETERNUS AF is identified according
to the instruction that is issued from ETERNUS Web GUI or ETER-
NUS CLI.
10
P3AG-1842-06ENZ0