2.
Basic Operation
Powering On and Off
1
Press the Power switch of the controller enclosure.
Power switch
The POWER LEDs on the controller enclosure and the drive enclosures are turned on.
2
After approximately five minutes, check that the READY LED of the controller enclosure is lit up.
Powering Off
This section explains how to turn off the ETERNUS AF.
To turn off the ETERNUS AF, perform one of the procedures below.
Via power switch
•
Press the Power switch to turn off the ETERNUS AF.
Via ETERNUS Web GUI or ETERNUS CLI
•
Use ETERNUS Web GUI or ETERNUS CLI to turn off the ETERNUS AF.
The following methods can be used to turn off the power by linking with the server.
Via the power synchronized unit
•
Use the power synchronized unit to turn off the ETERNUS AF.
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Operation Guide (Basic)
Copyright 2019 FUJITSU LIMITED
Controller enclosure
Drive enclosure
Controller enclosure
37
P3AG-1842-06ENZ0