Fujitsu ETERNUS AF250 S2 Basic Operation Manual page 66

5. Component Expansion/Function Enhancement
Installing Long Wave SFP+ Modules (16Gbit/s)
7
Install the Long wave SFP+ module (16Gbit/s).
(1)
Remove the connector cover attached to the port of the Long wave SFP+ module (16Gbit/s) and open
the lever.
Keep the removed connector cover in a safe place where they will not be lost.
(2)
Check the direction of the Long wave SFP+ module (16Gbit/s) and insert it all the way into the port
gauge.
(3)
Close the Long wave SFP+ module (16Gbit/s) lever downward.
8
Connect the FC cable that is disconnected in
Connect the FC cable connector to the FC port on the Long wave SFP+ module (16Gbit/s).
9
Repeat Step 5
10
If a wrist strap is used, remove the wrist strap.
11
Turn on the ETERNUS AF.
Refer to "Powering On" (page 36)
12
Check that the PORT LINK/FAULT LED for the FC port on the replaced Long wave SFP+ module (16Gbit/s)
turns off or lights up green.
13
Start ETERNUS Web GUI to check the status of the newly added Long wave SFP+ module (16Gbit/s).
On the Internal Parts information in the [Channel Adapter Details] screen of ETERNUS Web GUI, check that
the FC port status is Normal and the SFP type is changed to "16G SFP+(SMF)". In addition, confirm that all
of the other components are in normal status.
SFP+ module
Lever
When connecting the FC cables, position them so that they will not obstruct re-
•
placement of the power supply unit or controllers by the maintenance engineer.
through Step 8 to replace multiple SFP+ modules (16Gbit/s).
for details on how to turn on the ETERNUS AF.
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Operation Guide (Basic)
Copyright 2019 FUJITSU LIMITED
Step 5.
66
P3AG-1842-06ENZ0