Figure 3-2 Power Switch Location; Figure 3-3 Load Button (S1) Location - NEC SL1100 Hardware Manual
Hide thumbs
Also See for SL1100:
- Features and specifications manual (864 pages) ,
- Programming manual (650 pages) ,
- Networking manual (292 pages)
Table of Contents
Advertisement
SL1100
System software is loaded from flash memory, and the customer data is deleted
from RAM memory.
To perform a Cold Start;
1.
Set the power switch to off position.
2.
Open the Sub-Cover on the Main KSU and identify the LOAD button (S1) location on the CPU
card.
3.
Once the system has powered off, push in and hold the LOAD button (S1).
4.
Turn the power switch ON at the Main KSU.
5.
Continue holding the LOAD button (S1) for approximately three seconds or until Status LED (D5)
starts flashing red.
3-2
Figure 3-2 Power Switch Location
Figure 3-3 Load Button (S1) Location
ISSUE 1.0
System Start Up
Advertisement
Table of Contents
