Selecting The Best Location For Proper Installation; Selecting The Ksu Installation Site; Selecting A Permanent Mdf Location - NEC Electra Elite IPK II System Hardware Manual

Document Revision 3
___________________________________________________________________________________
2.3
___________________________________________________________________________________
5 - 2
The information obtained at the customer site can permit the installer to
partially assemble the MDF before installation at the customer premise. This
can reduce the time spent installing at the customer site and reduce
downtime.

Selecting the Best Location for Proper Installation

2.3.1

Selecting the KSU Installation Site

When selecting an installation site for the KSU, consider the
following conditions to ensure proper installation.
KSUs are normally wall mounted to protect against accident or
flooding.
The KSU should not be located directly beneath pipes. Leaks
or condensation could damage the Electra Elite IPK II system
equipment.
The area where the KSU is located must be free of corrosive
and inflammable gases, excessive chemical or industrial dusts,
and other materials that could cause a hazard to personnel or
to the proper functioning of the equipment.
The operating ambient temperature and humidity must be
within the limits specified in
Chapter 3 System
The operation of the system is virtually noiseless and allows
wide selection of installation sites. Take care to ensure the
KSUs do not present a hazard to office traffic. To minimize
cabling costs, a centralized location must be chosen.
Locate the KSU at a site where a dedicated AC power source
can be easily accessed.
Connect the KSU to a dedicated AC receptacle that is not
being used for any other device such as a computer, copier, or
facsimile machine.
2.3.2

Selecting a Permanent MDF Location

When selecting a permanent site for the MDF, the technician may
encounter some of the following conditions:
Limited space is available but must be used.
The available space may pose one or more environmental
hazards.
The proposed location has limitations such as insufficient
lighting or the lack of a suitable ground for the KSUs.
5.2.2 Environmental Conditions
Specifications.
Electra Elite IPK II
in
Installing KSUs