General Information; Programming Stations; Attendant Stations; Programming From A Pc - NEC Electra Elite IPK II System Hardware Manual

Hardware Requirements
___________________________________________________________________________________
S 1 G
ECTION
The technician should be familiar with the Electra Elite IPK II system before trying to
install it. Review this chapter carefully.
S 2 P
ECTION ROGRAMMING
Any multiline station can be a programming station in the Electra Elite IPK II system.
Station equipment connected to any port of an ESI(8)-U( ) ETU can be a
programming position, but requires a display multiline terminal.
S 3 A
ECTION TTENDANT
Any display Multiline Terminal can be programmed as an Attendant position in the
Electra Elite IPK II system. An Attendant Position can have up to four DCR-60-1
Consoles attached. Each Attendant Console must be supported by an ESI(8)-U( )
ETU. A maximum of four Attendant Consoles can be installed in each Electra Elite
IPK II system.
S 4 P
ECTION ROGRAMMING FROM A
Electra Elite IPK II systems can be programmed using a personal computer. The
available Graphical User Interface allows the technician/end-user easy access to all
information that can be programmed on the Electra Elite IPK II system. The PC must
be a Pentium III 600 MHz or higher PC and have a Windows operating system
compatible with the PC Programming (PCPro) application.
___________________________________________________________________________________
System Hardware Manual
I
ENERAL NFORMATION
S
TATIONS
S
TATIONS
PC
Chapter 4
4 - 1