NEC Electra Elite IPK II System Hardware Manual page 333

Electra Elite IPK II
___________________________________________________________________________________
___________________________________________________________________________________
System Hardware Manual
S3
S4
4. Strip one end of the cable to be connected to the control relay or door
box so that approximately 1/4" (8 mm) of bare wire is exposed.
5. Insert the cable in the proper CN4 or CN5 location while holding down
the lock button with a flat-head screwdriver. After the cable is in place,
release the lock button.
Refer to the specific function being connected for more detail on
PGD(2)-U10 ADP connections.
Open setting
S5
S6
Figure 7-6 Jumper Settings
Cable
8mm
Document Revision 3
Short setting
7 - 7