NEC Electra Elite IPK II System Hardware Manual page 424

Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
9 - 18
3. Install the ferrite core (provided with the unit) about two inches
from the line cord plug.
AP(A)-R Unit
or
AP(R)-R Unit
Figure 9-18 Installing the Ferrite Core on the AP(A)-R/
4. Connect the line cord to the unit, limiting the cable length from
the AP(A)/AP(R)-R Unit to the Single Line Telephone to a
maximum of 50 feet.
When only installing the AP(R)-R Unit, plug the AC Adapter
(AC-2R/AC-3R Unit) power cord into the indicated AP(R)-R
Unit receptacle and connect it to a power source. Refer to
Figure 9-5 Connecting the AC Adapter to an Installed Adapter
on page 9-5.
5. Replace the base plate (or wall mount unit) and attach the line
cord. Refer to Section 3 Connecting a Multiline Terminal to the
System on page
Installing Electra Elite IPK II Optional Terminal Equipment
AP(R)-R Unit
8-15.
Electra Elite IPK II