NEC Electra Elite IPK II System Hardware Manual page 468

Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
9 - 62
Series
term
D
Series i
3. Plug the interface unit into the right adapter connection as
shown on
Covers Removed
Figure 9-63 ADM and Multiline Terminal with Base Covers Removed
4. Place the interface unit cable in the cable channels on the ADM
and multiline terminal.
5. Install the connector plate provided with the ADM as shown in
Figure 9-64 Installing the Connector Plate
Table 9-12 DSW1 Switch Positions
Keyset Name
DTR/H-(8)/(16)D-2( ) TEL
DTR/H -16LD-2( ) TEL
DTR/H-16D(BL)-2( ) TEL
Figure 9-63 ADM and Multiline Terminal with Base
on the next page.
The connector plate cannot be used with Inaset terminals.
Installing Electra Elite IPK II Optional Terminal Equipment
Electra Elite IPK II
DSW1 Switch Positions
DSW1
ON
1 2 3 4 5 6 7 8
on the next page.