Outside Line Types; Transmission, Network, And Control Specifications; Transmission - NEC Electra Elite IPK II System Hardware Manual

Document Revision 3
___________________________________________________________________________________
5.4
5.5
___________________________________________________________________________________
3 - 26
Unit
Number
P64-U( ) PSU
P64-U( ) PSU
All fuses are normal blown glass tube.

Do not use slow blow fuses. Replace with a fuse of the same type and
rating.

Outside Line Types

The following outside lines can be used with the Electra Elite IPK II system:
2-wire, Loop Start or Ground Start Trunks
2-wire, 2-way DID Lines (Dial Pulse or DTMF)
4-wire, E&M Tie Lines (Type I or V, Dial Pulse, or DTMF)
Digital Trunk T1/FT1 (Loop Start, Ground Start, Tie Line (E&M), or DID
Signaling)
ISDN-BRI Trunks
ISDN-PRI Trunks
VoIP Trunks (Internet Protocols)
Refer to Table 1-1 FIC, REN, SOC, and Jacks for Electra Elite IPK II System
ETUs in the Regulatory Information section in this manual for a detailed list of
Facility Interface Codes, Ringer Equivalence Numbers, Service Order Codes
and Jack Types.

Transmission, Network, and Control Specifications

5.5.1

Transmission

Data Length:
From Multiline Terminal to ESI(8)-U( ) ETU: 23 bits
From ESI(8)-U( ) ETU to Multiline Terminal: 23 bits
Table 3-11 Fuse Replacement
Fuse
Specifications
F1 125V, 6.0A
F101 250V, 10A
Electra Elite IPK II
Description Dimensions
AC Input 1/4" x 1 1/4"
Battery Input 1/4" x 1 1/4"
System Specifications