Installing The Wall Mount Unit And Mounting The Multiline Terminal Using The Wmu-U Unit - NEC Electra Elite IPK II System Hardware Manual

Electra Elite IPK II
___________________________________________________________________________________
___________________________________________________________________________________
System Hardware Manual
11. When properly installed, the wall-mounted Multiline Terminal
looks similar to the one shown in
Mount
Do not adjust the tilt panel after the Multiline Terminal is
mounted on the wall.
3.9.3 Installing the Wall Mount Unit and Mounting the Multiline Terminal
using the WMU-U Unit
When installing any Adapter unit, a separate WMU-U Unit must be
purchased to accommodate this unit.
1. Remove the line cord, base plate and base cover from the
Multiline Terminal as shown in the previous section.
2. Cut off the tabs on the adapter as shown in
Removing the Tabs from the
Unit.
Figure 11-45 Installed Wall Mount Unit
Document Revision 3
Figure 11-45 Installed Wall
Figure 11-46
Adapter.
11 - 35