NEC Electra Elite IPK II System Hardware Manual page 156

Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
6 - 14
4. When the firmware has finished copying, LED 1 is on solid,
and LEDs 2~4 blink in unison. You can now remove the
Compact Flash Card, and toggle the SW2 reset switch.
5. After the system boots, check that the firmware was upgraded
by pressing the Feature key +3.
Remote Upgrade of the CPUII( )-U10 ETU Using PCPro
1. Before starting, make certain a Compact Flash is installed in
the CPU CN5 connector. Refer to the Installing a Compact
Flash section for more information.
2. Launch PCPro by selecting Start
Elite IPK II PCPro
3. Login to PCPro. The default login is tech with a password of
12345678.
4. Connect to IPK II by selecting Connect from the toolbar or
selecting Connect from the Communications Menu.
5. Define the connection information and click Connect.
6. From the Communications Menu, select Firmware Update.
The Firmware Update window displays.
7. In the Firmware File field, browse out to the location where you
stored the Firmware Package file provided by NEC.
8. Select the time when you want the update to be applied. After
PCPro uploads the Firmware Package file the system can reset
and switch to the new version immediately or at a scheduled
date and time.
The time specified is relative to the time on the KTS, not the PC
that PCPro was run from. Technicians must consider time
zones when scheduling updates.
9. Click Start to begin uploading the Firmware Package file. The
progress bar indicates the progress of the upload.
10. When the upload is complete, the progress bar indicates
Operation Complete.
→
Programs
→
Electra Elite IPK II PCPro.
Installing ETUs (Circuit Cards)
Electra Elite IPK II
→
Electra