NEC Electra Elite IPK II System Hardware Manual page 157

Electra Elite IPK II
___________________________________________________________________________________
___________________________________________________________________________________
System Hardware Manual
11. If you selected immediately after upload, the system resets and
switches to the new firmware version after one minute. If you
selected a time and date, the system resets and switches to the
new firmware on the time and date you specified.
12. Click Close to close the firmware window.
13. After a remote upgrade, the Compact Flash must remain in the
system. The CPUII( )-U10 ETU now boots from the Compact
Flash, not the onboard flash. If the Compact Flash is removed,
the system boots off the older version that is in the onboard
flash.
Up to two versions of firmware are kept on the
Flash
. One version is the current version that the CPU used to
boot from. The other version is the new version that is used on
the next boot up. If boot up fails, the CPU can revert back to
the older version.
14. To verify if the system was upgraded to the new firmware
version, reconnect with PCPro and check the version number
of the KTS in the lower right corner. The on site technician can
press the Feature Key +3 from any Multiline Terminal.
Remote Upgrade of the CPUII( )-U10 ETU Using WebPro
1. Prior to starting, make sure a Compact Flash is installed in the
CPU CN5 connector. Refer to Compact Flash section for more
information.
Select Start → Programs → Internet Explorer to launch
2.
WebPro.
3. From the File Menu, select Open and enter HTTP://
xxx.xxx.xxx.xxx where xxx.xxx.xxx.xxx is the IP address of the
CPUII( )-U10 ETU.
4. From the logon page, log into WebPro. The default login is
tech with a password of 12345678.
5. From the Administration section of the Home Page, Click the
Firmware Update icon.
6. In the Firmware File field, browse to the location where the
Firmware Package file provided by NEC is stored.
Document Revision 3
Compact
6 - 15