Installing Dsps On The Ctp( )-U10 Etu - NEC Electra Elite IPK II System Hardware Manual

Electra Elite IPK II
___________________________________________________________________________________
___________________________________________________________________________________
System Hardware Manual
3. Carefully lift the drive up to remove it from the ETU. You can
now access the DSP Module slots. Refer to
and Remove Drive from
7.3.6

Installing DSPs on the CTP( )-U10 ETU

Slot DSP Module 1 is always used so 4-port and 8-port configurations
have a DSP8-U10 in this slot only. Slot DSP Module 2 is used only
for 12-port and 16-port configurations.
1. Wear a grounding strap while handling the CTP( )-U10 ETU
and DSP, and lay both on a flat workspace.
2. The DSPs are installed under the drive, so the drive must be
removed first. Refer to section
instructions on removing the drive.
3. Start by inserting the end with the brass connectors into the
DSP Module 1 slot first. Refer to
Connector
ETU.
Figure 6-61 Lift up and Remove Drive from ETU
End.
Figure 6-62 Insert Brass Connector End
Document Revision 3
Figure 6-61 Lift up
7.3.5 Removing the Drive
Figure 6-62 Insert Brass
for
6 - 109