Rack Mounting The Basic Ksu - NEC Electra Elite IPK II System Hardware Manual

Document Revision 3
___________________________________________________________________________________
3.6
___________________________________________________________________________________
5 - 16

Rack Mounting the Basic KSU

The RAK-U( ) Unit is a 19 inch unit used to simplify installation by rack
mounting the Electra Elite IPK II system.
1. Mount the RAK-U( ) Unit to the equipment rack using the six provided
screws. Refer to
on the right side (at 1, 2, and 3) and three screws on the left side.
2. Mount the Wall Mount Bracket onto the RAK-U( ) Unit using the four
provided screws. Install two screws in the upper holes (at A) and two
screws in the lower holes (at A
3. After the bracket is mounted to the RAK-U( ) Unit, hang the KSU on the
two hooks protruding from the Wall Mount Bracket, as shown in
5-13 Hanging the KSU on the
Figure 5-12 RAK-U( ) Unit and
Figure 5-12 RAK-U( ) Unit and KSU
).
1
Bracket.
Electra Elite IPK II
KSU. Use three screws
A
1
A
1
2
3
RAK-U10 Unit
Figure
Installing KSUs