Installing D Term ® Handset Cordless Terminal; Description; Connecting The Telephone Cord; D Term - NEC Electra Elite IPK II System Hardware Manual

Electra Elite IPK II
___________________________________________________________________________________
S 7 I
ECTION NSTALLING
7.1
7.2
7.3
___________________________________________________________________________________
System Hardware Manual
term ®
D H
ANDSET

Description

term
This D Handset Cordless Terminal is a stand-alone telephone with direct
connection to a single port on the ESI(8)-U( ) ETU.
An ACA-U Unit adapter is required for this terminal.
Each terminal requires an ESI(8)-U( ) ETU port.
Selecting an Installation Location
Select a location for the DTP-16HC-1 TEL to avoid excessive heat or humidity.
The base unit should be placed on a desk or tabletop near a standard 120 Vac
outlet and within reach of the telephone line connection on the Electra Elite
IPK Multiline Terminal. Keep the base unit and the handset away from sources
of electrical noise ( e.g ., fluorescent lighting).

Connecting the Telephone Cord

The Base Unit of the DTP-16HC-1 TEL has two jacks on the back: LINE and
DC24V.
Observe the following warnings during installation:
Never install telephone wiring during a lightning storm.
Never touch uninsulated telephone wires or terminals unless the
telephone line is disconnected at the network interface.
Use caution when installing or modifying telephone lines.
Using the telephone line cord supplied with the terminal, connect the LINE
jack to the telephone line.
C T
ORDLESS ERMINAL
Document Revision 3
13 - 13