NEC Electra Elite IPK II System Hardware Manual page 272

Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
6 - 130
6. Wait for the APP1 LED to turn green, then connect the support
PC to the VMP(8)-U40 ETU.
7. Verify that eight ports are shown on the banner screen.
8. When the unit is to be installed at another location, shutdown
the voice mail application by pressing the ESC key.
9. Enter Y for yes, and enter the password (default is nec).
10. From the Utility menu enter x to exit to DOS.
11. Disconnect from the system.
12. Place SW3 in SHUTDOWN.
13. Wait for the shutdown LED to light red.
14. Turn OFF the KSU power and remove the ETU from the KSU.
15. Make sure to transport the ETU in the original packaging.
Electra Elite IPK II
Installing ETUs (Circuit Cards)