NEC Electra Elite IPK II System Hardware Manual page 268

Document Revision 3
___________________________________________________________________________________
J-7 — make sure
it is set to pins 2-
3 for hard drive.
___________________________________________________________________________________
6 - 126
3. Check jumper J-1 and make sure it is on pins 1-2. Refer to
Figure 6-71 Plus Sign on Battery Displayed
4. Insert Sony battery CR-2032 into BATT1 connector, the
should be facing up as shown in
Battery Displayed
Figure 6-71 Plus Sign on Battery Displayed Up
5. Insert keyed end of ribbon cable into connector CN8, the keyed
connector only goes into connector CN8 one way and should
not be forced. The red stripe of the cable is towards the bottom
of the ETU as shown in
Cable on page
Figure 6-71 Plus Sign on
Up.
Figure 6-72 Connecting the Ribbon
6-127.
Installing ETUs (Circuit Cards)
Electra Elite IPK II
Up.
+
sign
J-1 — make sure
it is set to pins
2-3.
BATT1 Connector
— install battery
+
with the facing
up.