Connection Example; Quick Setup And Configuration Procedures - NEC Electra Elite IPK II System Hardware Manual

Electra Elite IPK II
___________________________________________________________________________________
Electra Elite IPK II
IAD(8)-U( ) ETU
Megaco Station
Note 1: The IP-R Unit is equipped with a switching Hub function, enabling connection to personal
computers.
Note 2: When using 10 Base-T, a straight cable category 3 or higher is required (maximum length 100
meters). When using 100 Base-TX, a straight cable category 5 or higher is required (maximum
length 100 meters).
___________________________________________________________________________________
System Hardware Manual
3.7.4

Connection Example

Refer to Figure 9-37 Connection
LAN/WAN
LAN Connection
(Straight)
Note 2
Figure 9-37 Connection Example
3.7.5

Quick Setup and Configuration Procedures

This section provides step-by-step procedures for setting up and
configuring the
1. Connect the LAN port of the IP-R Unit to the network and the
PC port to an optional PC at your workstation. Plug in the
AC-R Unit.
2. The IP-R Unit automatically attempts to locate the DHCP
server when powered up. Wait until the server lookup times
out, and DHCP Server is Not Found is displayed on the
terminal, and then begin programming.
Example.
Connector for PC Connection
AC Adapter Connection
IP-R Unit.
Document Revision 3
Personal Computer
Note 1
AC Adapter
9 - 35