Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
6 - 108
7.3.5
Removing the Drive
1.
Loosen the four screws that hold the drive in place. Refer to
Figure 6-59 Loosen the Four
2.
After the four screws are loosened, push the drive towards the
back plane connector until it is unplugged from the drive
connector. Refer to
Screws.
Figure 6-59 Loosen the Four Screws
Figure 6-60 Push Drive Toward
Figure 6-60 Push Drive Toward Backplane
Installing ETUs (Circuit Cards)
Electra Elite IPK II
Backplane.