NEC Electra Elite IPK II System Hardware Manual page 491

Electra Elite IPK II
___________________________________________________________________________________
S 4 C
ECTION ONNECTING
An Attendant Console can be attached to a Multiline Terminal using the following
procedures.
1.
2.
3.
4.
5.
___________________________________________________________________________________
System Hardware Manual
A
TTENDANT
Turn the Multiline Terminal and the Attendant Console face down.
Using the joining plate provided with the Attendant Console, attach the plate to
the Multiline Terminal and the Attendant Console.
Connect the line cord and the AC adapter to the indicated locations on the
bottom of the Attendant Console.
Figure 10-11 Connecting the Line Cord and AC Adapter
When the Attendant Console and the Multiline Terminal are properly connected,
they sit side-by-side as shown in
Multiline Terminal.
Make sure that the AC adapter, supplied with the Attendant Console, is used.
Using a different AC adapter may cause problems. Check that the supplied
voltage matches that specified for the adapter and plug it in an outlet.
C M
ONSOLE TO A ULTILINE
when Installing a DCU Attendant Console
Figure 10-12 DCU Attendant Console and
Document Revision 3
T
ERMINAL
Line Cord Jack
AC Adapter Plug
10 - 11