Led Indications; Connectors - NEC Electra Elite IPK II System Hardware Manual

Electra Elite IPK II
___________________________________________________________________________________
___________________________________________________________________________________
System Hardware Manual
Slot ETU
N-2 BSU(6S) ETU
8.1.3

LED Indications

LIVE LED (Red)
8.1.4

Connectors

CN 1
CN 4
CN 5
The BSU(4M) has two serial interfaces: The upper port is for KGAP
Applications, Cable Delay Measurement, and Electra Elite IPK II to
Wireless – DECT administration. The lower port is for Applications,
telephone registration, and system information. The Administration
Program is used to communicate with ether port, depending on
operation required. The specifications for the Serial Ports are as
follows:
Specification
Connector
DCE/DTE
Speed
Data Length
Parity
Stop Bit
Flow Control
Channel BS No.
1 11
2 12
3 13
4 14
5 15
6 16
On indicates communication between this ETU
and the Main CPU.
Connects to the backboard.
Connects to RJ-45 connector at mid-top of the
BSU(2S) or BSU(6S) ETU.
Connects to RJ-45 connector at mid-bottom of
the BSU(2S) or BSU(6S) ETU.
RS-232C
DB-9 Female
DCE (connected by straight cable to PC)
19200 bps
8 bits
None
None
Hardware Handshake
Document Revision 3
Note
When BSU(2S) ETU is
installed, these numbers are
not assigned.
6 - 145