Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
11 - 12
3.2.3
Switch Settings
The DIP Switch is located at the bottom center of the ADA-U Unit.
The DIP Switch allows a technician to configure the board to specific
settings.
Figure 11-14 ADA-U Unit Switch Settings
settings.
The following switch settings should be made on the ADA-U Unit to
enable or disable the record start warning tone. Switch settings
should be made before installing the ADA-U Unit in the Multiline
Terminal. Refer to
Switch
SW1–1
On
SW1–2
Off
Dip Switch
Figure 11-14 ADA-U Unit Switch Settings
Table 11-2 ADA-U Unit Switch
Table 11-2 ADA-U Unit Switch Settings
Setting
When the ADA-U provides control to the
recorder, SW1-1 should be set to On,
otherwise set it to Off.
Leave Off
Installing Electra Elite Optional Terminal Equipment
Electra Elite IPK II
shows the default
Terminals
Default Settings
Settings.
Description