Load Push-Button Switch; Initialize Factory Defaults; Reset Cd-Vm00 (Apsu) - NEC Univerge UM8000 Installation Manual

Issue No. 1.0
L
S 3
OAD
ECTION
The Load push-button switch on the CD-VM00 Blade provides the following functions:
NOTE
3.1
3.2
6 - 4
4. Install the Compact Flash drive into slot CN7. Ensure the drive is
fully seated in the slot. Refer to
Flash Drive on page
P - S
USH BUTTON
Do not press the reset button while the voice messaging system is running. This can
corrupt the database.

Initialize Factory Defaults

To initialize factory defaults, perform the following steps:
1. Turn off power for the Chassis where the CD-VM00 is installed.
2. Press and hold the Load button on CD-VM00.
3. While holding the Load button, turn on Chassis power.
4. Continue to hold the Load button for 20 seconds.
5. Release the Load button.

Reset CD-VM00 (APSU)

To reset the CD-VM00, perform the following operation:
1. While the voice mail is running, hold the Load button for more than three
seconds.
6-4.
Figure 6-4 Install the Compact Flash Drive
WITCH
Figure 6-4 Install the Compact
Hardware
UM8000