Setting Up The System Overview - NEC Univerge UM8000 Installation Manual

UM8000
2.2
Installation Manual
Do not remove the UM8000 blade from the phone system while the voice
messaging system is running. Refer to
the Voice Messaging Software and
Control access to the room where the phone system and UM8000 are
installed. Do not install these systems in an area where unauthorized
persons might have access to them.
Failure to follow these recommendations can result in damage or unauthorized
access to the system and loss of data.

Setting Up the System Overview

The following is a summary of the major steps required to install a new UM8000
system. Detailed procedures are provided in the following chapters.
1. Verify that the installation and site requirements are met. Refer to Section
2.1 Site Recommendations on page 4-2
2. Install the voice blade.
This step is only required if you are replacing an existing voice blade. Refer
to Chapter 6 Hardware.
3. Establish a connection to the phone system.
4. Set up the phone system.
Refer to Chapter 10 Section
Chapter 4 Section
5. Set up the UM8000 software.
Refer to Chapter 8
6. Set up remote maintenance.
Refer to Chapter 11 Remote
7. Set up optional features:
For information on E-mail integration, refer to
For information about installing and configuring Visual Messaging, refer to the
Visual Messaging Installation Guide.
8. Optionally:
Upgrade version
Migrate OS/2 system
Migrate DOS system
9. Backup the voice messaging data.
For information, refer to
Chapter 5 Starting and Stopping
System.
3.1 Configuring TCP/IP on page 11-2
1.2 Configuring Internet Explorer on page
Section 5 Setting Up the UM8000 Software on page 9-12
Maintenance.
Chapter 12 Backing up and Restoring
Issue No. 1.0
in this chapter.
3-1.
Chapter 10 E-mail Integration.
UM8000.
and
4 - 3