Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
6 - 180
8.10.7
Connectors
The following connectors are used:
J1 Ethernet Connector
This connector is a single 10/100 Mbps Ethernet Connector.
This port has Auto-Medium Dependent Interface Crossover
(MDIX) to allow using either a straight-through Ethernet cable
for connection to a PC or a crossover Ethernet cable.
The Ethernet Interface setting allows manual configuration of
the Ethernet port from the Web Interface, and can be set to
operate in the following port speed and duplex mode
combinations: 10MB/Full Duplex, 10MB/HalfDuplex,100MB/
Half Duplex, or 100MB/Full Duplex, Auto-Negotiate.
J2 Serial Connector
This 10-pin serial terminal is used for debugging only.
J4 Compact Flash
Reserved for future use.
Electra Elite IPK II
Installing ETUs (Circuit Cards)