System Board Components - NEC Electra Elite IPK II System Hardware Manual

Electra Elite IPK II
___________________________________________________________________________________
___________________________________________________________________________________
System Hardware Manual
7.2.1.1

System Board Components

The components identified in
System Board
System Board
Table 6-34 System Board Components
Item
A Backplane connector
Switch SW2
B
Not used. Keep indicated default settings.
Switch SW1
C
Not used. Keep indicated default settings.
D Port Expansion Board (PEB) cable
E Modem connector
F Hard Drive (HD) LED
G Universal Serial Bus (USB) connector
H Local Area Network (LAN) connector
I Keyboard connector
J Mouse connector
K COM Serial Port connector
L VGA Monitor connector
Switch SW3
DIP switch 1 default is Off so the voice messaging
application starts when the board is turned On. Set
this switch On to start OS/2 software only.
M DIP switch 2 default is Off for direct serial remote
access connections. Set this switch On for modem
connections.
DIP switches 3 and 4 are not used and should be left
On.
The power button cuts the power to the board from
N
the PC and the hard drive and should not be used.
Voice messaging software LED
Green when software is active
O
Amber when active with possible application problem
Red when inactive or shut down
Figure 6-51 EliteMail CTI
are listed and described in
Components.
Description
Document Revision 3
Table 6-34
6 - 99