Installation And Setup; Installation; Line Voltage Settings; Installing And Charging The Battery - HP CodeMaster XL+ M1722A User Manual

A

Installation

1
The CodeMaster XL+ is ready for operation when the following tasks have been
properly performed:
o
o
o
o
o

Line Voltage Settings

The defibrillator automatically adjusts to the line voltage that is supplied (from 100–
230 VAC ± 15% at 50/60 Hz). No manual setting or adjustment is required.
Use only three wire power cords with three-pronged grounded
WARNING
plugs. Make sure that the outlet accepts the three-pronged plugs
and is grounded. Never adapt a three- pronged plug to fit a two-
pronged outlet.

Installing and Charging the Battery

To install the battery, refer to the battery replacement procedure in "Replacing the
Battery" (page 8-5). After installing the battery, connect the power cord to the back
of the defibrillator, then plug the cord into an AC outlet. The green
and
indicator lights when the instrument is plugged into AC power; the
indicator is on when the battery is installed and the instrument is plugged into AC
power.)

Installation and Setup

Install battery.
Charge battery (for 24 hours).
Install paper.
Make sure that the paddle set connector is seated and locked.
Select configuration settings; set date and time.
indicators on the front panel should light up. (The
BATT
AC
AC
BATT
A-1