Provider Mode (With Therapy Off) - Philips Respironics E30 User Manual

Philips Respironics E30 User Manual
3.9.1 Adjusting the humidifier settings
If you have a humidifier, you can adjust humidifier settings while the device is delivering therapy by
following these steps:
1. Turn the control dial in any direction to activate the humidifier setting.
2. Press the control dial to edit the setting.
3. Turn the control dial until you reach the desired setting. The setting increments when you turn the dial
clockwise and decrements when your turn the dial counter-clockwise.
4. Press the control dial to save the setting.

3.10 Provider mode (with therapy off)

When turned on, the device is automatically set in Provider mode to allow for modification of device
settings. You can choose between the following Provider mode screens, in addition to My Provider and My
Setup (not shown below).
If locked, Provider mode can be accessed by following these steps:
1. Supply power to the device (if not already).
2. Once the device is powered, press and hold both the control dial and the Ramp button
device for at least 5 seconds.
3. You are now in Provider mode.
3.10.1 Provider settings
The following sections will describe the options available from the Provider screens.
Therapy settings
Choosing this screen will take you to a sub-menu where you can adjust the device therapy
modes and pressure settings. These settings are described here.
Note
Not all settings shown here will display on the device. The display will vary based on therapy device
model and device settings.
22 Device setup
on the