Philips Respironics E30 User Manual page 59

Guidance and Manufacturer's Declaration - Electromagnetic Immunity – This device is intended for use in
the electromagnetic environment specified below. The user of this device should make sure it is used in such
an environment.
i T
mmuniTy EsT
Electrostatic Discharge
(ESD)
IEC 61000-4-2
Electrical fast Transient/
burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short
interruptions and voltage
variations on power
supply input lines
IEC 61000-4-11
Power frequency (50/60
Hz) magnetic field
IEC 61000-4-8
NOTE: UT is the a.c. mains voltage prior to application of the test level.
Guidance and Manufacturer's Declaration - Electromagnetic Immunity – This device is intended for use in
the electromagnetic environment specified below. The user of this device should make sure it is used in such
an environment.
i T iEC 60601 T
mmuniTy EsT
l
EvEl
Conducted RF 3 Vrms
IEC 61000-4-6 150 kHz to 80 MHz
6 Vrms
Amateur Radio & ISM
Bands between 150
kHz and 80 MHz
Radiated RF 10 V/m
IEC 61000-4-3 80 MHz to 2.7 GHz
iEC 60601 T l
EsT EvEl
±8 kV contact
±15 kV air
±2 kV for power supply
lines
±1 kV for input-output
lines
±1 kV differential mode
±2 kV common mode
<5% UT (>95% dip in
UT) for
0.5 cycle at 45 degree
increments
70% UT (30% dip in UT)
for 0.5 seconds
<5% UT (>95% dip in UT)
for 5 seconds
30 A/m
C
EsT omplianCE
3 Vrms
150 kHz to 80 MHz
6 Vrms
Amateur Radio & ISM
Bands between 150
kHz and 80 MHz
10 V/m
C l
omplianCE EvEl
±8 kV contact
±15 kV air
±2 kV for supply mains
±1 kV for input/output
lines
±1 kV differential mode
±2 kV for common mode
<5% UT (>95% dip in
UT) for
0.5 cycle at 45 degree
increments
70% UT (30% dip in UT)
for 0.5 seconds
<5% UT (>95% dip in UT)
for 5 seconds
30 A/m
l E
EvEl lECTromagnETiC
Portable and mobile RF communications equipment
should be used no closer to any part of the device,
including cables, than the recommended 30 cm separation
distance.
Interference may occur in the vicinity of equipment marked
with the following symbol:
Philips Respironics E30 User Manual
E E
lECTromagnETiC nvironmEnT
g
uidanCE
Floors should be wood, concrete
or ceramic tile. If floors are covered
with synthetic material, the relative
humidity should be at least 30%.
Mains power quality should be
that of a typical home or hospital
environment.
Mains power quality should be
that of a typical home or hospital
environment.
Mains power quality should be
that of a typical home or hospital
environment. If the user of the
device requires continued operation
during power mains interruptions,
it is recommended that the device
be powered from an uninterruptible
power supply.
Power frequency magnetic fields
should be at levels characteristic of a
typical location in a typical hospital
or home environment.
E - g
nvironmEnT uidanCE
Specifications
-
53