Huawei FusionModule1000A40 Commissioning Manual page 41

FusionModule1000A40 Prefabricated All-in-One Data
Center
Commissioning Guide
Step 2 For details about how to commission cameras and set parameters for them, see the delivered
documents.
1.
2.


3.
4.
Issue 04 (2020-01-17)
Preview the site situation in real time and check the camera coverage through videos.
Adjust the lens if necessary.
Set IP address, Subnet mask, and Gateway IP address to the planned values.
Figure 7-1 Basic camera configuration
Scenario without a VCN: Connect the signal cables of the indoor and outdoor cameras to the PoE
ports on the smart ETH gateway. If the current network is configured with a server that uses
Dynamic Host Configuration Protocol (DHCP) and the camera can automatically obtain the IP
address, the system will automatically configure the IP address, subnet mask, gateway IP address,
and DNS.
Scenario with a VCN: Connect the signal cables of the indoor and outdoor cameras to the LAN
switch. You need to set the IP address for the outdoor camera as planned.
(Optional) Format the SD card.
If a VCN is not configured and an SD card is configured, format the SD card.
a. Choose Settings > System Configuration > Storage Management.
b. The Storage Management page is displayed. Format the SD card.
Figure 7-2 Formatting the SD card
Set the camera stream type and primary stream parameters.
Copyright © Huawei Technologies Co., Ltd.
7 System Commissioning
35