Optional) Configuring The Ip Address For An Outdoor Camera - Huawei FusionModule1000A40 Commissioning Manual

FusionModule1000A40 Prefabricated All-in-One Data
Center
Commissioning Guide
Skill requirement: weak-current engineer familiar with the management system
Procedure
Step 1 Commission the ECC800.
1.
2.
Verify that all devices in the initial configuration table communicate with the management
system properly.
3.
Step 2 (Optional) Commission the NetEco management system.
1.
2.
Verify that all devices in the initial configuration table communicate with the management
system properly.
3.
----End
7.3.3 (Optional) Configuring the IP Address for an Outdoor
Camera
Procedure
Step 1 Log in to the camera WebUI.
1.
2.
Issue 04 (2020-01-17)
Enter the initial user name and password on the ECC800 WebUI to log in to the ECC800
WebUI.
Check the connections of all monitoring devices by referring to the monitoring device
layout diagram.
Check that the views in the management system are consistent with the running status of
the data center. If any inconsistency is found, contact Huawei technical support.
Enter the initial user name and password on the NetEco WebUI to log in to the
management system.
Check the connections of all monitoring devices by referring to the monitoring device
layout diagram.
Check that the views and videos in the management system are consistent with the
running status of the data center. If any inconsistency is found, contact Huawei technical
support.
Configure the PC IP address and the camera IP address in the same network segment.
Enter the camera IP address (192.168.0.120 by default) in the address bar of the Internet
Explorer and press Enter.
Enter the preset user name admin and the preset password HuaWei123, and click Log
In.
Copyright © Huawei Technologies Co., Ltd.
7 System Commissioning
34