Installing A Water Sensor; Optional) Installing A Camera - Huawei FusionModule500 User Manual

FusionModule500 Smart Mini Data Center
User Manual (ECC800e)
Figure 2-31 Equipment layout in the network cabinet

2.2.7.2 Installing a Water Sensor

Procedure
Step 1 Remove the rodent-proof mesh from the bottom of the cabinet and tailor the mesh.
Step 2 Route the cable of the water sensor through the rodent-proof mesh and connect it to the water
signal cable terminal which is connected to the ECC800.
Step 3 Place the water sensor on the floor under the rodent-proof mesh.
Step 4 Fix the rodent-proof mesh.
----End

2.2.7.3 (Optional) Installing a Camera

Prerequisites


Context
This section describes how to install and commission a camera. Two persons are required for
the commissioning.
In a 42 U single cabinet scenario, the camera needs to be installed on the top of the front door
of the cabinet. In the multi-cabinet scenario, the camera is installed on the top of the front
door of the leftmost cabinet.
Procedure
Step 1 (Optional) Install an SD card.
1.
Issue 07 (2019-12-20)
The cable is polarity insensitive.
A camera and tools for installing it have been prepared.
The network cable used for camera communication has been prepared.
The current camera series support only SD cards.
Loosen the screws on the front cover of the camera using a wrench, remove the front
cover, and take out the inner cover over the lens, as shown in
Copyright © Huawei Technologies Co., Ltd.
2 Installation
Figure 2-32.
49