Connecting Vcn Cables - Huawei FusionModule500 User Manual

FusionModule500 Smart Mini Data Center
User Manual (ECC800e)
No.
2
Step 2 Connect one end of the power cable to the power port on the LAN switch rear, and connect
the other end to the server.
----End

2.3.3.6 Connecting VCN Cables

Prerequisites
Cables have been prepared.
Procedure
Step 1 Secure one end of the ground cable to the ground terminal on the VCN and the other end to
the ground point on the cabinet using a Phillips screwdriver.
Step 2 Connect one end of the network cable to the GE1 port on the VCN and the other end to the
PoE_1 port on the smart ETH gateway.
Figure 2-90 Ports on the VCN
(1) Ground point
(4) Power input port
Issue 07 (2019-12-20)
Description
configured.
 3: Connects to the CIM1 when two battery cabinets are configured.

4: Connects to the CIM2 when two battery cabinets are configured.
 21: (Optional) Connects to the server.

22: (Optional) Connects to the camera.
 23: (Optional) Connects to the VCN.

24: Connects to a WAN port on the ECC800e.
NOTE
When a camera is configured, a LAN switch with the PoE function is required. The camera
needs to be connected to the PoE port on the LAN switch.
Port for large throughput (connecting to the Internet).
Copyright © Huawei Technologies Co., Ltd.
Figure 2-90 shows the ports on the VCN.
(2) GE2 port
(5) GE1 port
2 Installation
(3) Power switch
95