Commissioning A Smoke Sensor; Commissioning A Door Status Sensor - Huawei FusionModule500 User Manual

FusionModule500 Smart Mini Data Center
User Manual (ECC800e)

3.2.6.2 Commissioning a Smoke Sensor

Procedure
Step 1 Check functions of the smoke sensor.
Table 3-6 Commissioning the smoke sensor
Check Method
Simulate a smoky environment
under the smoke sensor.
----End

3.2.6.3 Commissioning a Door Status Sensor

Procedure
Step 1 (Optional) Set parameters for the door status sensor.
1.
2.
Step 2 Check the monitoring functions of door status sensor.
Table 3-7 Commissioning the sensor
Check Method
Open the cabinet door.
----End
Issue 07 (2019-12-20)
Power off and reset the smoke sensor, remove the wiring terminal, and reconnect it to the ECC800e.
Set the sensor type to Smoke sensor.
In the multi-cabinet scenario, this operation should be performed for the door status sensors on the
network cabinet and battery cabinet.
On the WebUI, choose Monitoring > System > Faraway_AI/DI Group > Faraway
AI/DI > Running Parameters > AI/DI_3 Port Settings, set AI/DI_3 Sensor to Enable,
click Submit. Configure the AI/DI_3 Sensor Name according to the naming rules,
check the AI/DI_3 Sensor Type to Door Sensor, and click Submit.
Perform the preceding operations to set parameters for ports AI/DI_1 to AI/DI_3.
Copyright © Huawei Technologies Co., Ltd.
Normal Connection Status
A smoke alarm is displayed on the active alarm page of
the App or WebUI.
Normal Connection Status
A door status alarm is displayed on the active alarm
page of the App or WebUI.
3 Commissioning Guide
108