Canon Staple Finisher-D1 Service Manual page 168

4) Push back the saddle stitcher unit gently into the
finisher until it stops.
F-6-31 F-6-31
6) Connect the connector of the booklet tray to the connector on the lower left side, and then attach the booklet tray using its two hooks.
x1
Caution:
When attaching the booklet tray, be careful not to pinch or damage the connecter and the cable harness. After attaching the booklet tray,
put the connecter and the cable harness inside of the finisher. Do not put the connecter and cable harness at outside of the finisher.
6
Installation > Unpacking and Checking the Contents > Unpacking Procedure of the Saddle Unit [Booklet Finisher-D1 Only]
5) Close the front cover.
6 Installation > Unpacking and Checking the Contents > Unpacking Procedure of the Saddle Unit [Booklet Finisher-D1 Only]
F-6-32 F-6-32
F-6-33 F-6-33
6-15
6-15