Canon Staple Finisher-D1 Service Manual page 55

2
Technology > Detecting Jams > Detecting Jams
- Saddle Finisher (Booklet Finisher)
2
Technology > Detecting Jams > Detecting Jams
Whether jam is occurred or not, determined by whether there is paper or not in the sensor
area by the time of timing check that memorized in advance by Finisher Controller PCB and
Saddle Stitcher Controller PCB.
When Finisher Controller PCB or Saddle Stitcher Controller PCB detected jam, it will break
feeding/delivery movement. And at the same time inform the connection machines about the
jam occurrence.
Jam type
Early arrival jam S101
Finisher staple
jam
Finisher Power-on
jam
Door open jam
Finisher inlet
sensor delay jam
Finisher feed path
sensor delay jam
Finisher inlet
sensor stationary
jam
Finisher feed path
sensor stationary
jam
Finisher error
detection jam
F-2-55 F-2-55
Sensor Jam description
When the reception distance of the host machine delivery
signal is short more than specified time for the sheet
processing time of previous notice.
When executing the staple processing, the staple HP sensor
S131
(S131) doesn't detect the home position within the specified
time (distance) after the staple HP sensor (S131) goes OFF.
S101, S102 When paper is detected by the inlet sensor (S101), or the
feed path senor (S102) that the cover is opened/cosed.and
during power on.
S129 When the front door sensor (S129) detects that the cover is
opened during movement.
The inlet sensor (S101) doesn't detect ON within the
S101
specified time (distance) after the controller judged that
paper arrived at the finisher inlet.
The feed path sensor (S102) doesn't detect ON within
S102
the specified time (distance) after the inlet sensor (S101)
detects paper.
The inlet sensor (S101) doesn't detect OFF within the
S101
specified time (distance) after the controller judged that end
of the paper arrived at the finisher inlet.
The feed path sensor (S102) doesn't detect OFF within the
S102
specified time (distance) after the inlet sensor (S101) goes
OFF.
When the controller detected the following errors during
-
movement.
•
Error in the gripper motor (E514)
•
Error in the front alignment motor (E530)
•
Error in the stapler shift motor (E532)
Error in the swing guide motor (E535)
•
• Error in the rear alignment motor (E537)
•
Error in the paper return guide motor (E578)
•
Error in the paper trailing edge pushing guide motor
(E57B)
•
Error in the stacking tray paper retainer motor (E56D)
Error in the feed roller disengage/buffer flapper motor
•
(E568)
• Error in the processing tray paper retainer motor (E57C)
•
Error in the tray auxiliary guide motor (E583)
•
Error in the tray 1 shift motor (E540)
•
Error in the tray 2 shift motor (E542)
Error in the stack delivery lower/shutter motor (E584)
•
2-33
Code
1200
1500
1300
1400
1001
1002
1101
1102
110F
2-33