Canon Staple Finisher-D1 Service Manual page 42

2
Technology > Processing Tray Unit > Staple Operation
<Rear 1-Point Stapling>
Alignment position: Sheets are aligned to the center when the paper width is more than 216
mm. Sheets are aligned to the position 15 mm rearward from the center when the paper width
is 216 mm or less.
Alignment Plate (rear)
Feed direction
Alignment Plate (front)
2 Technology > Processing Tray Unit > Staple Operation
Staple Position
Stopper
F-2-31 F-2-31
<2-Point Stapling>
Sheets are stapled at the rear, and then stapled at the front.
Alignment position: Sheets are aligned to the center. When the stack consists of 20 or fewer
sheets of A4R/LTRR/B5R paper, they are first stapled at the rear, shifted 43 mm frontward
from the center, stapled at the front where the gripper does not touch the stapler, and
delivered by the gripper immediately.
Alignment Plate (rear)
Feed direction
Akignment Plate (front)
2-20
Stopper
Staple Position
Stopper
Staple Position
Stopper
F-2-32 F-2-32
2-20