Canon Staple Finisher-D1 Service Manual page 91

4
Parts Replacement and Cleaning Procedure > Main Units > Removing the Processing Tray Unit
5) Remove the E-ring at the rear side and shift the bearing to the
front.
8) Remove the 2 screws.
x2
4 Parts Replacement and Cleaning Procedure > Main Units > Removing the Processing Tray Unit
6) Shift the drive shaft to the rear to release it from the front belt.
F-4-61 F-4-61
9) Grip the motors at the lower part of the processing tray unit.
F-4-64 F-4-64
7) Shift the drive shaft to the front to release it from the rear
belt, and then remove the drive shaft.
F-4-62 F-4-62
10) Shift the left hand side of the processing tray unit to the
rear, and then draw out the processing unit from the right
hand side.
F-4-65 F-4-65
4-31
F-4-63 F-4-63
F-4-66 F-4-66
4-31