Starting/Stopping/Aborting A Program - Siemens SINUMERIK 840D Operation/Programming Manual

2
Operation
2.10 Automatic mode

2.10.3 Starting/stopping/aborting a program

Precondition
Starting execution
Cycle Start
Stopping the program
Cycle Stop
Aborting execution
Reset
2-118
When you select a program for the first time for execution, that
contains the cycles "Stock removal towards contour" or "Contour
pocket", the individual stock removal steps or solid machining steps
for the contour pocket are calculated automatically. This process may
take several seconds depending on the complexity of the contour.
Shows how to start/stop programs that are loaded in "Machine Auto"
operating mode and resume program execution after abnormal
program termination.
Once the program is loaded in "Machine Auto" mode, and "Automatic"
mode is also activated on the machine control panel, you can start the
program whatever your current operating area, even if you are not in
"Machine Auto" mode.
This start option must be enabled in a machine data code.
Please refer to the machine manufacturer's instructions.
No alarms are pending.
The program is selected.
Feedrate enable is active.
Spindle enable is set.
Press the "Cycle Start" key.
The program is started and executed from the start or from the
selected program block onwards.
Press the "Cycle Stop" key.
Machining stops immediately, individual blocks do not finish execu-
tion. At the next start, execution is resumed at the same location
where it stopped.
Press the "Reset" key.
Execution of the program is interrupted. When it is started again, it will
execute from the beginning.
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
2
10.04
 Siemens AG, 2004. All rights reserved