3
10.04
Opening the program
editor
Selecting a program
block
Mark
Copying a program
block
Copy
Cutting a program block
Cut
Pasting a program block
Insert
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
3.3 Creating a sequential control program
Select a program.
Press the "Expansion" key.
The softkeys for the program editor are displayed in the vertical
softkey bar.
Place the cursor in the machining plan on the first or last block
you want to select.
Press the "Mark" softkey.
Use the cursor keys to select any further program blocks.
The program blocks are marked.
Select the program block(s) in the machining plan.
Press the "Copy" softkey.
The program blocks are copied into buffer memory.
Select the program block(s) in the machining plan.
Press the "Cut" softkey.
The program blocks are removed from the machining plan and stored
in buffer memory.
Copy or cut the desired program blocks in the machining plan.
Place the cursor on the line after which the program block(s) is
(are) to be inserted.
Press the "Insert" softkey.
The program blocks are inserted in the machining plan of the
program.
Programming with ShopMill
3
3-183