Siemens SINUMERIK 840D Operation/Programming Manual page 374

6
File Management
6.3 Program management with PCU 50
Running a G code program
from floppy disk or network
drive
...
-or-
Continue Exec. from
> hard disk
Cycle Start
6-374
Open the Program Manager.
Select the floppy disk/network drive via the appropriate softkey.
Place the cursor on the directory that contains the G code
program you want to execute.
Press the "Input" or "Cursor right" key.
The directory opens.
Place the cursor on the G code program you want to execute.
Select the "Continue" and "Exec. from hard disk" softkeys.
ShopMill switches to "Machine Auto" mode and uploads the G code
program.
Press the "Cycle Start" key.
Workpiece machining is initiated (see also Sec. "Automatic mode").
The program contents are loaded continuously to the NC main
memory while the program is being processed.
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
6
10.04
 Siemens AG, 2004. All rights reserved