Siemens SINUMERIK 840D Operation/Programming Manual page 402

8
Alarms and Messages
8.1 Cycle alarms and messages
61302
61303
61308
61309
61310
61311
61316
61332
61338
61605
61610
62100
62101
62103
61275
62180
8-402
"Probe collision"
"Safe area exceeded"
Check measuring path 2a
Check probe type
Scaling factor is active
No D number is active
Center point and radius cannot be
calculated
Alter the tool tip position
Positioning speed is zero
"Contour incorrectly programmed" Check the contour.
"No infeed depth programmed"
"No drilling cycle active"
"Milling direction incorrect - G3 will
be generated"
"No finishing allowance
programmed"
"Destination point violates
software limit switch!"
"Set rotary axes ... "
The measuring probe collided with an obstacle
when being positioned.
• Check spigot diameter (it may be too
small)
• Check measuring path (it may be too long)
Measuring result deviates greatly from specified
value for the spigot/hole diameter.
Check radius or diameter.
Check measuring location (e.g. for inaccuracies
caused by swarf)
Measuring path = 0 entered
Check MD 9752, 9753, 9754, 9755
Probe type: 3D probe not active
Scaling factor = scaling is active
No tool offset for the measuring probe (for
workpiece measurement) or no tool offset for
the active tool (for tool measurement) is
selected.
It is not possible to calculate a circle from the
measured points.
Tool tip is positioned below the probe surface
(e.g. with a setting ring gauge or cube)
Set corresponding feedrate (plane/infeed rate)
via MD 9757 or 9758
The infeed depth must be programmed
No modal drilling cycle has been called before
the drilling pattern cycle.
Climb or conventional milling programmed.
However the spindle was not rotating when the
cycle was called.
Program a finishing allowance.
Swiveling has placed the destination point
outside the software limit switch.
You may have to choose a different preferred
direction for swiveling or place the retraction
plane lower.
Prompt to position rotary axes manually.
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
8
10.04
 Siemens AG, 2004. All rights reserved