Siemens SINUMERIK 840D Operation/Programming Manual page 381

6
10.04
Stop
Importing a program
Continue Read in
>
RS-232
settings
Start
Stop
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
6.3 Program management with PCU 50
The "Readout" window displays the name of the program that has just
been read out and the number of bytes transferred.
Press the "Stop" softkey if you want to interrupt data transfer.
Then press the "Start" softkey again to restart data transfer.
Open the Program Manager.
Select the "Continue" and "Read in" softkeys.
Press the "RS-232 settings" softkey to set up the interface.
Enter the desired settings.
Press the "Back" softkey.
The settings for the interface are saved.
On the partner system, select the programs that you want to read
in.
Start the transfer on the partner system.
Press "Start" softkey.
The "Read in" window displays the name of the program that has just
been read in and the number of bytes transferred. The program is
stored in the directory specified in the program header.
Press the "Stop" softkey if you want to interrupt data transfer.
Then press the "Start" softkey again to restart data transfer.
6
File Management
6-381