Configuration In The Sitop Ups Manager; General Settings - Siemens SITOP UPS1600 Manual

Engineering and remote access
3.5 SITOP UPS Manager
3.5.8

Configuration in the SITOP UPS Manager

Once you have connected the SITOP UPS1600 and the SITOP UPS Manager, you have the
following configuration options:
● Create a new configuration.
● Load a configuration from a data medium or from a device.
● Change a configuration.
● Store a configuration on a data medium or load it into a device.
Procedure
1. Make the required hardware configuration in the SITOP UPS Manager.
Alternatively, you can load a saved hardware configuration to the UPS Manager using
command "Open file" in the storage bar "Configurations".
2. Click in the storage bar "Configurations" on the "Download" button.
The configuration is loaded to the SITOP UPS1600.
Note
When storing or loading a HW configuration, the entry in "Base unit > Location" is not
accepted/changed.
3.5.8.1

General settings

Under "Software configuration > General settings", specify the maximum size of the log file in
Kbytes and where it is saved.
From SITOP UPS Manager V4.12.5 and higher, under "Software configuration > General
settings" you can also specify as to whether the window of the SITOP UPS Manager should
always be in the foreground.
Log file
1. Select "Software configuration > General settings".
2. Enter the maximum file size in kbytes in the "Size of log file" dialog box.
3. Click on "Browse"
4. Select the directory in which the log file should be stored.
5. Confirm with "Select folder".
The maximum size and the storage location of the log file has been saved.
100
SITOP UPS1600 / UPS1100
Manual, 04.2016, A5E37775406-6-76