Usb Port; Profinet/Ethernet Connection - Siemens SITOP UPS1600 Manual

Pin Terminal designation
8 -
9 ON/OFF
10 -
11 BAT. X2.1
12 BAT. X2.2
13 INTERRUPT
14 START
Relay contact: Maximum contact rating 30 V DC / 1 A or 125 V AC / 0.3 A
The jumper (4a) (see Image 2-5 Signal connector (Page 18)) between pin 9 and 10 is
necessary to operate the device in buffer mode.
Delivery state: Jumper between pin 9 and 10
2.2.1.3

USB port

Image 2-7
The USB interface (type B)
(see Section USB connector (Page 140)) is implemented using a defined cable/connector
(Y-Con USB - Yamaichi).
2.2.1.4

PROFINET/Ethernet connection

Image 2-8
Ethernet interface
(100BASE-TX) according to IEEE 802.3..
SITOP UPS1600 / UPS1100
Manual, 04.2016, A5E37775406-6-76
Function
REL3 (NO contact):
Energized state: Buffering of the selected buffer time is possible, or charge state
>85%
On/Off (buffer operation permitted/prevented)
-
Battery communication or charging current setting
Battery supply or charging current setting
Interrupt (interruption of the output voltage)
Start from the battery
USB port
⑥
fully conforms to the USB 2.0 standard (12 MBd). Strain relief
PROFINET/Ethernet connection
⑤
corresponds to the standard full duplex with up to 100 Mbit/s electrical
Description, device design, dimension drawing
2.2 Connections and terminal designation
19