Siemens SITOP UPS1600 Manual page 93

Installation paths without blanks
Note
Paths must not contain any blanks!
The path names of the directories for SITOP UPS Manager and batch files must not contain
any blanks.
Installation steps
Procedure when installing for the first time
1. Close all applications before you start the installation.
2. Double-click on the "Setup_SITOP-UPSManager_x.xx.x" file.
3. Follow the installation instructions. Enter the requested information in the dialogs:
– Installer language, English or German
– Agreement declaration with the license conditions
– Installation scope:
– Installation path:
– Start menu folder
4. If you are using a SITOP UPS1600 with USB interface, then connect the
SITOP UPS1600 to the computer using this interface.
5. Click "Finish" to complete the installation.
Procedure for an already existing installation
Note
The procedure described below is only necessary if a SITOP UPS Manager with version
number less than 4.50 is to be installed. These steps are automatically executed for versions
from V4.50 and higher.
1. Back up the file "dcups.ini", which is located in directory "ini" in the installation directory of
the SITOP UPS Managers.
2. Carry out steps 1 to 5 of the procedure described above when installing for the first time.
3. Replace file "dcups.ini", which is located in directory "ini" in the installation directory of the
SITOP UPS Managers, as a result of the file backed up in Step 1.
SITOP UPS1600 / UPS1100
Manual, 04.2016, A5E37775406-6-76
Activate option "USB driver" if your SITOP UPS1600 has a USB interface. You can
select between application and service.
Use the recommended target directory "C:\Program Files (x68\SITOPUPSManager" or
select another one. If you select another target directory, please note that spaces are
not permissible in the path name (to be taken into consideration up to version 4.61).
Select the folder structure under which the SITOP UPS Manager should appear in the
start menu.
Engineering and remote access
3.5 SITOP UPS Manager
93