Mitsubishi Electric GOT1000 Series Connection Manual page 251


Ethernet setting
Item Description
The host is displayed. (The host is
Host
indicated with an asterisk (*).)
Set the network No. of the
N/W No. connected Ethernet module.
(Default: blank)
Set the station No. of the
*1
connected Ethernet module.
PLC No.
(Default: blank)
Type KEYENCE (fixed)
Set the IP address of the
IP Address connected Ethernet module.
(Default: 192.168.0.10)
Set the port No. of the connected
Port No. Ethernet module.
(Default: 8501)
UDP, TCP
Communication
(Default: UDP)
*1 Each of [GOT PLC No.] set in the communication detail
setting and [PLC No.] set in the Ethernet setting must be set
to different station numbers.
 Communication detail settings
POINT POINT POINT
(1) Communication interface setting by the Utility
The communication interface setting can be
changed on the Utility's [Communication setting]
after writing [Communication Settings] of project
data.
For details on the Utility, refer to the following
manual.
User's Manual of GOT used
(2) Precedence in communication settings
When settings are made by GT Designer3 or the
Utility, the latest setting is effective.
6.3.3
POINT POINT POINT
KEYENCE PLC
For details of KEYENCE PLC, refer to the following
manual.

KV-LE21V/KV-LE21V setting
Set the IP address and port No. by the unit editor of KV
Set value
STUDIO.
-
Item
Communication
1 to 239
mode
IP address
1 to 254
Port No.
(Host link)
KEYENCE
(fixed)
PLC side IP
address
PLC side port
No.
Adjust the
settings with the
PLC settings.
6. CONNECTION TO KEYENCE PLC
PLC side setting
KEYENCE PLC user's Manual
Description
Ethernet
*1
Set the IP address.
*1
Set the port No.
*1 Adjust the settings with the Ethernet settings of the GOT
side.
■ Ethernet setting
6.3 Ethernet Connection
1
2
Range
3
-
0.0.0.0 to
255.255.255.255
256 to 65534
4
5
6
7
8
6 - 19